GTCO Roll-Up Digitizer - New and Refurbished Models

• Refurbished
  • Refurbished Roll-Up II
  • Refurbished Roll-Up III
• Parts
• Drivers
• Documentation
•  

Roll Up Digitizer Requirements

Computer (not required if connecting to a QuikRuler) - The Roll Up Digitizer will connect to most any PC with a serial port or USB port. The digitizer uses the TabletWorks driver which is included with the digitizer. TabletWorks is a WinTab application which will operate with any digitizer application.

Digitizer Software (not required if connecting to a QuikRuler) - If you are currently using a design, estimating, takeoff, or CAD/CAM application, contact your software vendor to ask if the application contains a digitizer module or functionality. Intermediary applications can be used to create files for importing into your current package if it does not contain a digitizer module or digitizer functionality. See our list of common applications with digitizer functionality: List

Digitizer Placement (Desk, Drafting Table, Pedestal, Digitizer Workstation) - Digitizers may be placed on the top of a desk or drafting table. Smaller models like the 2024, 2436, 3036 are small enough to place on most desks. Large format models like the 3648 and 4460 usually require a large drafting table, pedestal, or digitizer work station. Larger format models require more tilt than smaller models. The tilt allows the user to more easily reach the opposite side of the digitizer with the pointer. A pedestal or digitizer workstation can be bundled  with a Roll Up Digitizer. The Roll Up Digitizer requires the Tabletop add-on if it is to be used with a Pedestal. ...More

Pointing Devices (Also referred to as: Pucks, Transducer, Digitizer Mouse, Pen) - The Roll Up Digitizer works with corded pointers only.

Three styles of pointing devices: Pen Stylus, 4 Button Cursor, 16 Button Cursor.

Pen Stylus - Most commonly used for point-to-point takeoffs and the easiest pointer to use. Points are selected by pushing down with the pen so the tip is depressed (clicks). The Pen Stylus can also be used to trace by dragging the pen while keeping the tip depressed. The pen also has two side buttons which can be used to perform different functions depending on your software application. Accuracy can vary slightly depending on the angle of the pen when the user is using the digitizer. Patented technology inside the Pen Stylus corrects for most variation caused by the angle of the pen at contact.

Cursor (Puck, Digitizer Mouse) - The cursor is also preferred by users who have to trace contour lines because they are easier to follow with the crosshairs in the cursor magnifying window than with the pen stylus. The cursor is usually more precise because the angle of the contact does not vary. This level of accuracy is more important with very large engineering scales and also with high accuracy digitizer units.

The only difference between the 4 Button version and the 16 Button version is the number of buttons. Some users prefer the larger number of buttons because it allows them to program more functions to operate their digitizer software without using the computer mouse. (Example: AutoCAD)

Look at Refurbished Roll Up Models with 12-Month Warranty - Refurbished GTCO Roll Up

Roll Up Digitizer - GTCO CalComp